| Sizes | 14", 16" |
|---|
The installation of the Hydra-Stop Insta-Valve Plus 250 insertion valve is accomplished through a single circular hole — commonly known as a “tap” — cut under full line pressure into the top of the pipe without the need to ream or sever the pipe. By installing the Insta-Valve Plus 250 right where a control point is needed, you gain a permanent asset allowing system control and maintenance in the same manner as a resilient seated gate valve.
To select your valve, follow the step-by-step guide in “Build Your Valve” below. If the valve size you require is not listed or you need additional help in selecting the correct valve for your project, please call Inside Sales at 708-389-5111.
The recommended excavation size for the 14″–16″ Insta-Valve Plus 250 is 6′ x 6′ and a depth of 1′ below the main.
Yes, the Insta-Valve Plus 250 can be installed on all common types of pipes, including AC, CI, DI and PVC pipe.
Yes. By reversing the installation process, you can simply install a new IVP gate if needed.
Yes, the Insta-Valve Plus 250 can be installed in as little as three to four hours. Simply install the valve body, make a line tap and install the gate.
The EPDM gate paddle is compressed, allowing for expansion of the rubber to seal on the inside diameter of the pipe. The gate seal seals onto the gate housing, lower gate housing O-ring and valve body to complete the seal.
The Insta-Valve Plus 250 is currently available in 14″ and 16″ sizes.
