Insta-Valve 20-24

  • Requires no system shutdown
  • Eliminates 100 percent of the costs related to shutting down a system
  • Engineered valve cartridge for a drip tight seal
  • 150 psi working pressure, however the qualification process to obtain a 250 psi pressure rating is underway and is expected soon
  • Ductile iron valve construction with fusion-bonded epoxy coating
  • Permanent asset for site-specific control
  • Can be installed on ductile iron (DI) and cast iron (CI) pipes in as little as 4 hours
  • No need to ream or sever the pipe, only a single tap needed for installation
  • Bevel gear available for horizontal installation

Additional information

Sizes

20", 24"

How It Works

The installation of the Hydra-Stop Insta-Valve 20-24 insertion valve is accomplished through a single circular hole — commonly known as a “tap” — cut under full line pressure into the top of the pipe without the need to ream or sever the pipe. By installing the Insta-Valve 20-24 right where a control point is needed, you gain a permanent asset allowing system control and maintenance in the same manner as a resilient seated gate valve.

How to Order

To select your valve, follow the step-by-step guide in “Build Your Valve” below. If the valve size you require is not listed or you need additional help in selecting the correct valve for your project, please call Inside Sales at 708-389-5111.

Build Your Line Stop Fitting

Build Your Valve

FAQ

Videos

Insta-Valve 20-24 Looking for a quote on Insta-Valve 20-24? Get in touch with us to receive an itemized quote. Get a Quote Looking for a quote on
Insta-Valve 20-24?
Get in touch with us
to receive an itemized quote.